Note: each of the 4 legs are numbered as show on the picture and this number corresponds with the same number in the corner blocks of the table

Step1.

Place the tabletop on the floor bottom side up. Then remove the washers and nuts from the bolts in the legs.

Step 2.

To attach the leg to the bottom of the table, carefully insert the two lag bolts into the two holes at the corner of the table. The lag bolts are to be inserted from the outside of the corner, through the support block, and toward the center of the tabletop. Place one washer and then one nut on each lag bolt and finger tighten.

Step 4.

Tighten each nut one revolution clockwise. Make sure the leg is attached securely and does not move around.

Now turn table upright and enjoy!