Instructions

Note that you received 2 sizes of the same diameter bolts.

All short bolts are used to connect the seat and are used from the bottom inside.

All long bolts are used to fasten the side sections and are used from the outside of the chairs or benches.

Note that the left and right side sections can be easily recognized by the inserted nuts in the seat support on the INSIDE of each of the sides

Step 1

Place the seat section on one of the side sections in such a way that the overlapping seat slat is on the front side of the chair or bench

Step 2.

Insert the 3 SHORT bolts into the holes of the seat section

Step 3.

Use the special key provided to connect loosely the seat section with the side section. Do not tighten the bolts yet.

Step 4.

Repeat the same steps 2 and 3, above, for the attaching, loosely, the other side section to the seat section.

Step 5.

Insert one LONG bolt in the hole in the front of the side section and loosely connect with the seat section using the special key. Do not tighten them yet. Repeat on the opposite side.

Step 6.

Insert the back section between the back supports of the side sections and insert the 4 LONG bolts (2 on each side) with the special key.

Now you can firmly tighten all bolts of your chair or bench with the key. Turn upright and enjoy.

Shown the two sizes of the bolts you received with your furniture.